Using slate tile in the backsplash has become a fashion nowadays since slate stone is so incomparable. The beautiful waves and drawings of the slate stone embellish your entire kitchen and give it a touch of elegance and style. So are you ready to transform your kitchen into a beautiful haven? If yes, then go further and read the instructions on how to install the slate tile backsplash.

Things Needed to Install Slate Tile Backsplash

• Tile boxes (about 50 tiles per box). The number of cases needed depends on the area you want to cover. The cost of a case is approximately $11.
• three tubes of adhesive
• One bag of Type S Gray High Strength Mortar/Stucco Mix
• Loctite Power Grab
• angle grinder
• Dry Tile Saw Blade
• paint brush
• caulking gun
• black permanent marker
• safety glasses
• cement board

Tips for Installing Slate Tile Backsplash

• Before buying anything check your wall. It should be strong enough to support the weight of the slate tiles, and if you are using 12×12″ tiles, first secure the cement backer board to the wall with screws. Use caliper screws every six inches for proper fixing.
• Now, if you want the sealer, it’s best to apply it before the slate tile installation. Apply it a day before and allow the tiles to dry completely.
• Make the plan on how you want to install the tile. Before placing it on the backsplash, it is best to make the arrangement on the floor or other solid surface. Here you can opt for the color scheme and style.
• Wear safety glasses and apply Loctite Power Grab adhesive in the caulking gun.
• Find the center of the backsplash wall and mark it with the marker. Your first slate stone tile will appear there and then you will place the other one on either the left or right side of it. Lay the slate tile evenly and leave adequate space between the tiles. For this you can use tile spacer. There should also be space between the countertop and the tile. Use the adhesive you have made to stick the tiles on the wall.
• Do the second and third row in the same way.
• For the last row, the tiles must be cut according to the available space.

grout

• Before applying the grout, allow the slate to dry. Now prepare the mixture for the grout. For this, add the right amount of water to the grout powder and its consistency should be like peanut butter. If so, then your grout mix is ​​ready to go.
• Apply it to the entire surface of the slate tile backsplash and push it into the gaps between the tiles and the walls. Once finished, let it rest for at least 20 minutes. Now clean off the extra grout from the surface and sides. But don’t do anything to the grout line.
• Wait 72 hours after this, and then apply a penetrating sealer over the backsplash.